Electric steam humidifier to automatically generate and discharge mineral-free, odourless and sterile vapour. Designed for direct room humidification in steam baths. Completely assembled into housing with bottom of plastic (corrosion resistant), shaped into water collecting pan, water carrying parts and electronics separated

Direct connection to all standard water mains supplies with permitted water pressure of max. 1 – 10 bar

Water quality: tap water with a conductivity of125...1250 µS/cm

Permitted ambient temperature of max. 1…40°C and ambient humidity 75 % r.h.

The steam capacity can be set on the integrated, high quality electronic device type M4 which ensure an optimised energy usage, comprehensive operational safety and self-adaptation to the prevailing water conditions. The maximum steam capacity is programmed and stored on the electronic chip CP2.

Built-in: Integrated solenoid inlet and drain valve, disposable electrode steam cylinder with gold plated lamellar cylinder plugs for maximum energy transfer. Electronics with operation switch and drain key as well as 4-line alpha numeric LCD display. Proportional control by direct connection to commercially available humidity controllers.
For the mounting required bolts, screws and hose clamps are included.

Conformity to EN-Norms, VDE/GS/DVGW approved, quality monitoring complying with ISO 9001:2000, Type of protection IP20

Heating voltage: 400V / 230V 3-phase 50…60Hz
Control voltage: 230V 1-phase

Optional : Fragrance pump with electric plug

Option steam bath DT with temperature sensor, signal converter, remote operating and fault indication