Electric steam humidifier to automatically generate and discharge mineral-free, odourless and sterile vapour. Units are available for duct application or direct room humidification through blower.

Completely assembled into housing. Water carrying parts and electronics are separated. Direct connection to all standard mains water supplies with permitted water pressure of max. 1 - 10 bar.
Quality: tap water with a conductivity of 125...1250 µS/cm Permitted ambient temperature of max. 1.40°C and ambient humidity 75 % r.h.
Integrated high quality electronics ensure an optimised energy usage, comprehensive operational safety and self-adaptation to the prevailing water conditions. The maximum steam capacity is programmed and stored on the electronic card CP3.

ON/OFF or Continuous control by direct connection to commercially available humidity sensors and controllers.
Built-in: integrated inlet valve and drain pump, disposable electrode steam cylinder made of temperature- and long-term stable plastics with silvered plated lamella cylinder plugs for maximum energy transfer. Electronic with operation switch and drain key as well as three LED signal lamps. Automatic system check at initial start-up. For the mounting required screws, bolts and hose clamps are included.
Conformity to EN-Norms, VDE/GS/DVGW approved, quality monitoring complying with ISO 9001:2000, Type of protection IP20.

Heating voltage: 400V / 220V (other heating voltages upon request)
Control voltage: 230V (other control voltages upon request)

Options:
cleanable steam cylinder
Unit box in stainless steel